Introduction

Follow this guide to remove and replace, repair, or clean the access door.

Image 1/2: Remove the hex head bolt from the top of the access door on the pump head. Image 2/2: On reassembly, this bolt should be hand-tight.
  • Before performing any repairs, perform a water test on the pump by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

  • Remove the hex head bolt from the top of the access door on the pump head.

  • On reassembly, this bolt should be hand-tight.

Add Comment

Image 1/3: Store the access door in a sanitary place to prevent contamination. Image 2/3: Store the access door in a sanitary place to prevent contamination. Image 3/3: Store the access door in a sanitary place to prevent contamination.
  • Pull the access door straight up off the pump head.

  • Store the access door in a sanitary place to prevent contamination.

Add Comment

Image 1/2: The access door makes a convenient tray to hold nuts and bolts during the disassembly. Image 2/2: The access door makes a convenient tray to hold nuts and bolts during the disassembly.
  • The access door has a tongue that fits into the base of the pump head.

  • The access door makes a convenient tray to hold nuts and bolts during the disassembly.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Andrew Optimus Goldberg

Member since: 10/17/2009

326,452 Reputation

873 Guides authored

Team

iFixit Member of iFixit

Community

126 Members

5,826 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 92