Introduction

Follow this guide to remove the access door of an India Mark II for repair or replacement.

Before performing any repairs, perform a water test on the pump by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters. Remove the hex head bolt from the top of the access door on the pump head.
  • Before performing any repairs, perform a water test on the pump by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

  • Remove the hex head bolt from the top of the access door on the pump head.

  • On reassembly, this bolt should be hand-tight.

Add Comment

Pull the access door straight up off the pump head. Store the access door in a sanitary place to prevent contamination. Store the access door in a sanitary place to prevent contamination.
  • Pull the access door straight up off the pump head.

  • Store the access door in a sanitary place to prevent contamination.

Add Comment

The access door has a tongue that fits into the base of the pump head. The access door makes a convenient tray to hold nuts and bolts during the disassembly.
  • The access door has a tongue that fits into the base of the pump head.

  • The access door makes a convenient tray to hold nuts and bolts during the disassembly.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldberg

Member since: 10/17/2009

336,235 Reputation

1,015 Guides authored

Team

iFixit Member of iFixit

Community

130 Members

6,638 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 12

All Time: 255