Introduction

Use this guide to replace the headphone jack in your Huawei P9 smartphone.

Image 1/3: Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port. Image 2/3: If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone. Image 3/3: If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.
  • First switch off your phone and remove the SIM card tray.

  • Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port.

  • If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

Add Comment

Image 1/2: Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit. Image 2/2: Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.
  • Use an iSclack or a suction handle to separate the display unit from the rear panel.

    • Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

If you cant get suction because of cracks in the screen, use wide tape to create smooth surface.

Kent Alexander Johansen - Reply

If your screen is smashed, and nothing else will work (iSclack etc), you can get a thin blade between the casing and the screen assembly and the bottom. The screen assembly can then be pried out. I fought with mine before discovering this. Be careful of the broken glass.

Rob Collins - Reply

I struggled to remove screen with suction cups due to damage to the back case. I used a jim to pry from bottom by usb c port, worked well.

Philip Lloyd - Reply

Image 1/3: Image 2/3: Image 3/3:
  • Disconnect the finger print sensor using a spudger.

Add Comment

Image 1/3: Undo the two Phillips #000 screws. Image 2/3: Remove metal bracket (mind the adhesive underneath). Image 3/3: Remove metal bracket (mind the adhesive underneath).
  • Remove the water indicator on top of the screw.

  • Undo the two Phillips #000 screws.

  • Remove metal bracket (mind the adhesive underneath).

Add Comment

Image 1/2: The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack. Image 2/2: The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack.
  • Disconnect the flex cable and remove the headphone jack.

  • The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tobias Isakeit

Member since: 03/31/2014

10,717 Reputation

91 Guides authored

Team

iFixit Member of iFixit

Community

127 Members

5,780 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 25

Past 30 Days: 118

All Time: 547