Huawei Ascend P6-U06 Battery Replacement

Step 1 SIM Card



• Pull and twist the pin near the bottom left-side of the phone to remove it from the headphone jack.
Step 2



• Insert the pin into the SIM card opening located on the right-side of the phone.
• Gently push in until the SIM card clicks, and then pull the pin and SIM card out.
• Repeat this process for the additional SIM card.
Step 3 Back Panel
• Firmly push down on the black plastic covering at the bottom of the phone, and pull down.
• You may need a sharp thin object to get underneath the plastic.
Step 4
• Rotate the phone 180 degrees so that the bottom of the phone is now facing up.
• Firmly push up on the back panel with your thumbs.
• Lift up the back panel from the top right corner and gently pull it away from the phone.
Step 5 Battery
• Remove the following screws securing the logic board to the main frame:
• Five 2mm Phillips #000 screws
• Two 2.5mm Phillips #000 screws
Step 6
• Push down the yellow plastic lining at the top of the battery and remove the two 2.5mm Phillips #000 screws.
Step 7
• Use the flat end of a spudger to gently snap open the first clip located on the the right arm of the retaining plate.
• Use the flat end of a spudger to gently snap the second clip located on the left arm of the retaining plate.
• Use the flat end of a spudger to gently lift the upper retaining plate from the phone.
Step 8
• Use the pointy end of a spudger to pry the antenna connector off of its socket.
• Upon reassembly, you will hear a "click" that indicates the pin has been properly reconnected.
Step 9
• Use the pointy end of a spudger to gently pry the following connectors out of their sockets:
• silver LCD cable connector
• silver Headphone jack cable connector
Step 10
• Use the pointy end of a spudger to gently pry the following connectors out of their sockets.
• Sliver Micro-USB cable connector
• Copper battery cable connector
Step 11
• Be careful not to bend, puncture, or crush the battery, even if it is being replaced. The battery can potentially release toxic and flammable chemicals.
• Use a plastic opening tool to gently lift up the battery from the bottom end.
• You may need to loosen the adhesive under the battery with slow sawing motions.

Author

with 5 other contributors

Chase Hemming

Member since: 10/14/14

2,623 Reputation

4 Guides authored

Badges: 19

• 
• 
• 

+16 more badges

Team

Cal Poly, Team 4-44, Amido Fall 2014 Member of Cal Poly, Team 4-44, Amido Fall 2014

CPSU-AMIDO-F14S4G44

5 Members

11 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview