Introduction

This guide will show how to remove the back cover of the Skytex SP728 and identify the buttons on the side of the device. These buttons are used to raise or lower the volume and to power the device on or off.

Image 1/1: Rotate the device so the ports and screws face you
  • Make sure the device is powered off

  • Rotate the device so the ports and screws face you

Add Comment

Image 1/1:
  • Using a small phillips screwdriver, unscrew both end screws

Add Comment

Image 1/1:
  • Using a plastic opening tool, work your way around the edge of the device, separating the case from the rest of the device

Add Comment

Image 1/1: Make sure to remove the case gently as extra force can break the clasps or the case itself.
  • Once the case has been loosened, pry the backing off gently with your hands.

  • Make sure to remove the case gently as extra force can break the clasps or the case itself.

Add Comment

Image 1/1:
  • Remove the black buttons (they should not be directly attached to the device and may fall out).

Add Comment

Image 1/1:
  • On side the circuit board there will be three buttons. One is the power button, and the other two are volume buttons.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Chris Nelson

Member since: 01/21/2015

213 Reputation

2 Guides authored

Team

USF Tampa, Team 5-1, Brown Winter 2015 Member of USF Tampa, Team 5-1, Brown Winter 2015

USFT-BROWN-W15S5G1

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 67