Introduction

Has debris found its way between the casing and the screen? Use this guide to remove and clean the screen.

As handling the display housing may damage the wire strip, use caution.

Image 1/1: Using a spudger (not shown), gently pry apart the external and internal covers until the sides start to separate.
  • On the door's bottom edge, locate the gap between the external and internal screen covers.

  • Using a spudger (not shown), gently pry apart the external and internal covers until the sides start to separate.

  • Continue working your way along the edges of the phone, alternating sides, until the external cover can be easily removed.

Add Comment

Image 1/2: Image 2/2:
  • On the display housing, locate and unscrew the four corner T6 Torx screws connecting the housing and the internal cover.

Add Comment

Image 1/2: Locate the gap between the display housing and internal cover, in the same manner you would flip open the phone, use your finger (not shown) to lift the housing from the cover and set it down. Image 2/2: Locate the gap between the display housing and internal cover, in the same manner you would flip open the phone, use your finger (not shown) to lift the housing from the cover and set it down.
  • The fragile wire strip connecting the display housing to the circuit board is located on the left side of the inner hinge.

  • Locate the gap between the display housing and internal cover, in the same manner you would flip open the phone, use your finger (not shown) to lift the housing from the cover and set it down.

Add Comment

Image 1/1:
  • Using a lens cloth, wipe away any dust or debris from the display or screens.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Amy

Member since: 10/15/2012

1 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 198