Introduction

More information can be found on RockShox.

Image 1/3: Screw your suspension pump into the designated thread. Image 2/3: Go on and give your suspension fork some pressure! Consider the weight table printed on to your fork. Image 3/3: Go on and give your suspension fork some pressure! Consider the weight table printed on to your fork.
  • Remove the cap on the left side of the suspension fork.

  • Screw your suspension pump into the designated thread.

  • Go on and give your suspension fork some pressure! Consider the weight table printed on to your fork.

- You might consider adding a link to a suspension pump, lik this: https://www.amazon.de/SKS-Luftpumpe-SAM-...ämpferpumpe-10059/dp/B000X5YIBE/

- Also, Newbies don't know, how to set the right pressure. how to measure 20 % sag, etc. It's very easy, though.

- As it is part of the setup, you could add the settings for the rebound as well.

Hans Dorsch - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tobias Isakeit

Member since: 03/31/2014

10,717 Reputation

91 Guides authored

Team

iFixit Member of iFixit

Community

127 Members

5,780 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 11

Past 30 Days: 62

All Time: 476