Introduction

Reshaping the contact point electrodes which hold bObi's dustbin in place can resolve installation and bin latching difficulties.

Remove bObi's dustbin: Push down on the button found on bObi's back to release the dustbin. Push down on the button found on bObi's back to release the dustbin.
  • Remove bObi's dustbin:

    • Push down on the button found on bObi's back to release the dustbin.

Add Comment

Inside bObi are two contact point electrodes, secured with a small red fastener and two screws. Use a screwdriver to reach underneath the electrodes and pull upward gently to bend them back to the correct shape. Use a screwdriver to reach underneath the electrodes and pull upward gently to bend them back to the correct shape.
  • Inside bObi are two contact point electrodes, secured with a small red fastener and two screws.

  • Use a screwdriver to reach underneath the electrodes and pull upward gently to bend them back to the correct shape.

Add Comment

When the electrodes are fixed, slide the dustbin back into bObi. The HEPA filter side of the dustbin should face down. Ensure it locks in place, and the contact point electrodes will line up correctly, so bObi can resume functioning.
  • When the electrodes are fixed, slide the dustbin back into bObi. The HEPA filter side of the dustbin should face down.

  • Ensure it locks in place, and the contact point electrodes will line up correctly, so bObi can resume functioning.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Chelsea

Member since: 09/24/2014

2,251 Reputation

31 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 110