Fix Your Stuff Community Store

How to Fix A Loose RCA RT3205 TV Stand

Introduction

Use this guide to repair a loose TV stand on an RCA RT320 TV. If you’re not wall-mounting your TV, the TV stand is the most important when it comes to properly orienting your TV and preventing damage. If the stand is loose, something during the installation process was done incorrectly.

Do not apply excessive force as this may damage the holes. The TV panel may be awkward to install so instead of installing the stand alone, you may ask someone else for assistance.

The repair doesn’t require any prior knowledge or experience related to fixing things.

What you need

  1. How to Fix A Loose RCA RT3205 TV Stand, How to Fix A Loose RCA RT3205 TV Stand: step 1, image 1 of 1

    • Place a soft cushioned material on top of a flat surface, like a table.

    • This is to prevent damaging the TV screen panel.

    • Make sure your path towards the TV is clear of any obstructions. If not, remove all obstacles.

    Edit

  2. How to Fix A Loose RCA RT3205 TV Stand: step 2, image 1 of 3 How to Fix A Loose RCA RT3205 TV Stand: step 2, image 2 of 3 How to Fix A Loose RCA RT3205 TV Stand: step 2, image 3 of 3

    • Unplug the TV set from the power supply.

    • Keep TV set unplugged until repair is completed.

    • Failure to unplug the TV can result in a hazardous situation which, if not avoided, could result in death or serious injury.

    Edit

  4. How to Fix A Loose RCA RT3205 TV Stand: step 3, image 1 of 1

    • Place the TV monitor flat on top, with the screen side facing down.

    Edit

  5. How to Fix A Loose RCA RT3205 TV Stand: step 4, image 1 of 1

    • Align the stand(s) onto the bottom of the TV.

    • If the stands have been installed already, remove them and realign.

    Edit

  6. How to Fix A Loose RCA RT3205 TV Stand: step 5, image 1 of 2 How to Fix A Loose RCA RT3205 TV Stand: step 5, image 2 of 2

    • Align the screw holes on the stand and to the bottom of the TV.

    Edit

  7. How to Fix A Loose RCA RT3205 TV Stand: step 6, image 1 of 1

    • Gently tighten the screws with a screwdriver to fasten the stand to the panel.

    • A table knife can be used in place of a screwdriver.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 6

All Time: 621