Introduction
Use this guide to create a custom cotton swab for cleaning electronic components with small openings, such as charging ports.
Most commercially-sold cotton swabs are too thick to fit into small openings or have wispy cotton that gets caught on sharp edges. These custom cotton swabs are thinner and have compacted cotton to make your device-cleaning life easier.
What you need
-
-
Find a small object with a pointed end, such as:
-
A toothpick
-
A spudger
-
The end of a flossing pick
-
-
-
-
Wrap the cotton around the tip of your tool.
-
Roll the cotton between your fingers to compress it into a thin layer.
-
-
-
Test your cotton swab on your device to see if it fits.
-
If your swab doesn't fit, remove any excess cotton and reroll your cotton so it's compressed and tight along the tip of your tool.
-
Your custom cotton swab is ready! Return to where you left off in your guide.
-
For other general electronics skills guides, click here.
For other general electronics skills guides, click here.
Cancel: I did not complete this guide.
3 other people completed this guide.
