Hover-1 Matrix LED Replacement
Jici Zhuang and 5 other contributors
Last updated on Dec 16, 2021
Views: 718
View statistics:
- Past 24 Hours:
- 0
- Past 7 Days:
- 8
- Past 30 Days:
- 67
- All Time:
- 718
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Introduction
Go to step 1 ↓When the Hover-1 Matrix is turned on, the LED light in the board will glow to show you that it is on. It is an important part of the hoverboard because it lights up the path in front of you. If you have a broken LED it could lead to injuries.
If you have already tried other troubleshooting methods, and have not found a solution, this guide will teach you how to replace the LED light in your Hover-1 Matrix.
What you need
-
-
-
Flip the board over to remove the screws from the back panel using a Phillips #1 screwdriver.
Ask FixBot
-
-
-
Remove the screws on the metal layer inside using the Phillips #0 screwdriver.
-
-
-
-
Remove the two screws from the circuit board.
-
Remove the circuit board and LED light.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
UC Davis, Team S7-G2, Lore Fall 2018 Member of UC Davis, Team S7-G2, Lore Fall 2018
UCD-LORE-F18S7G2
3 Members
48 Guides authored
