Introduction
In order to replace most parts in this saw, you will first need to remove this housing by unscrewing the nine screws located around the saw. If the housing is either broken or cracked. It can be easily replaced by following the steps below.
What you need
-
-
Remove the nine torx 15.875mm screws on the front of the jigsaw using a T-15 torx screwdriver.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Cal Poly, Team 22-9, Maness Winter 2017 Member of Cal Poly, Team 22-9, Maness Winter 2017
CPSU-MANESS-W17S22G9
4 Members
7 Guides authored
