Fix Your Stuff Community Store

Harman Kardon Invoke LED Board Replacement

Introduction

If the LED lights do not function after troubleshooting, you might need to change the LED Board. For this replacement you need a Phillips #2 screw driver and a metal spudger.

What you need

  1. Harman Kardon Invoke LED Board Replacement, LED Board: step 1, image 1 of 3 Harman Kardon Invoke LED Board Replacement, LED Board: step 1, image 2 of 3 Harman Kardon Invoke LED Board Replacement, LED Board: step 1, image 3 of 3

    • Use a metal spudger to remove the top cover.

    • Use a Phillips #2 screwdriver to remove three 17 mm screws.

    Edit

  3. Harman Kardon Invoke LED Board Replacement: step 2, image 1 of 3 Harman Kardon Invoke LED Board Replacement: step 2, image 2 of 3 Harman Kardon Invoke LED Board Replacement: step 2, image 3 of 3

    • Grip larger cable connected to LED board and pull volume wheel until both are disconnected from the cable.

    • Pull lightly on the LED board to disconnect the smaller LED board cable from volume wheel.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 8

All Time: 508