Parts

No parts required.

Image 1/2: Notice the tab connecting the flip cover to the back of the PDA. Image 2/2: Gently push tab forward.
  • Place Visor Edge face down.

  • Notice the tab connecting the flip cover to the back of the PDA.

  • Gently push tab forward.

  • Do not pull on the flip cover to try and remove it from the PDA.

Add Comment

Image 1/1:
  • Once flip cover is removed, turn over and remove the four 3.9 mm screws connecting the hinge.

Add Comment

Image 1/2: Be careful to pull out evenly and not bend the plastic, as it can crack.The spring may also shoot out if it is not pulled out evenly. Image 2/2: Be careful to pull out evenly and not bend the plastic, as it can crack.The spring may also shoot out if it is not pulled out evenly.
  • Gently pull away the plastic hinge from the cover.

  • Be careful to pull out evenly and not bend the plastic, as it can crack.The spring may also shoot out if it is not pulled out evenly.

Add Comment

Image 1/1: Reinsert new spring.
  • Turn the hinge piece on its side or use a screwdriver to pull out the spring.

  • Reinsert new spring.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Blaize Steiger

Member since: 01/30/2011

101 Reputation

1 Guide authored

Team

Cal Poly, Team 11-28, Maness Winter 2011 Member of Cal Poly, Team 11-28, Maness Winter 2011

CPSU-MANESS-W11S11G28

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 949