Fix Your Stuff Community Store

Handset Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

Introduction

Prerequisite Only

What you need

  1. Handset Replacement, Battery: step 1, image 1 of 2 Handset Replacement, Battery: step 1, image 2 of 2

    • Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.

    Edit

  2. Handset Replacement: step 2, image 1 of 1

    • Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.

    Edit

  4. Handset Replacement, Handset: step 3, image 1 of 1

    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

    Edit

  5. Handset Replacement: step 4, image 1 of 2 Handset Replacement: step 4, image 2 of 2

    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

    Edit

  6. Handset Replacement: step 5, image 1 of 2 Handset Replacement: step 5, image 2 of 2

    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 3 other contributors

Caleb Thomas

Member since: 09/29/16

161 Reputation

2 Guides authored

Badges: 3

Team

IUPUI, Team 3-3, Harley Fall 2016 Member of IUPUI, Team 3-3, Harley Fall 2016

IUPUI-HARLEY-F16S3G3

4 Members

17 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 50