Introduction

Replacement of the power cord. Make sure to keep the processor unplugged until finished with replacement.

Turn the bowl counterclockwise and lift. Turn the bowl counterclockwise and lift.
  • Turn the bowl counterclockwise and lift.

Add Comment

Using a #2 Phillips head screwdriver, remove the two 11 mm screws from the base. Pull suction cups straight out.
  • Using a #2 Phillips head screwdriver, remove the two 11 mm screws from the base.

  • Pull suction cups straight out.

Add Comment

Remove rubber caps using the heavy duty spudger. Remove the four 11 mm screws using the #2 Phillips head screwdriver. Pull base straight out.
  • Remove rubber caps using the heavy duty spudger.

  • Remove the four 11 mm screws using the #2 Phillips head screwdriver.

  • Pull base straight out.

Add Comment

Black Friday
Broken doesn't stand a chance.
Using a #2 Phillips head screwdriver, remove the four 9 mm screws. From the open base pull the motor straight out. From the open base pull the motor straight out.
  • Using a #2 Phillips head screwdriver, remove the four 9 mm screws.

  • From the open base pull the motor straight out.

Add Comment

Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor and then rewire the new power cord to the motor.
  • Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor and then rewire the new power cord to the motor.

Add Comment

Remove the two 12 mm screws using the #2 Phillips head screwdriver. Remove plastic  piece.
  • Remove the two 12 mm screws using the #2 Phillips head screwdriver.

  • Remove plastic piece.

Add Comment

Remove the three 12 mm screws using the #2 Phillips head screwdriver. Remove the plastic piece by pulling straight up.
  • Remove the three 12 mm screws using the #2 Phillips head screwdriver.

  • Remove the plastic piece by pulling straight up.

Add Comment

Remove the power cord from the ground by removing the solder with the soldering tool. Solder the new ground from the new power cord.
  • Remove the power cord from the ground by removing the solder with the soldering tool.

  • Solder the new ground from the new power cord.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Travis Williams

Member since: 02/02/2017

501 Reputation

5 Guides authored

Team

USF Tampa, Team 17-4, Blackwell Spring 2017 Member of USF Tampa, Team 17-4, Blackwell Spring 2017

USFT-BLACKWELL-S17S17G4

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 4

All Time: 52