Introduction

The drive shaft is essential and may possibly have a stripped gear, causing the blade not to turn. There are several steps in order to take this out and replace it. Beware of lubricant along the bottom of it.

Parts

No parts required.

Remove the cover by turning it in the counterclockwise direction.
  • Remove the cover by turning it in the counterclockwise direction.

Add Comment

Remove the bowl scraping mechanism by simply grabbing the middle section and lifting.
  • Remove the bowl scraping mechanism by simply grabbing the middle section and lifting.

Add Comment

  • Remove the blade mechanism by lifting it off of the blade shaft.

Add Comment

  • Place hands on bowl and turn it gently, but firmly, counter-clockwise.

Add Comment

  • Make sure there is no food or grime along the outside sides of the bowl or the base.

Add Comment

  • Using the metal spudger, remove the four adhesive plastic covers that hide the screws.

  • These covers are adhered to the screws.

Add Comment

  • Remove any access glue that is adhered to the screws with the precision tweezers.

Add Comment

  • Using a JIS #1 driver, remove the four 10 mm screws.

Add Comment

  • Lift the drive shaft.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mack Bernard

Member since: 03/08/2016

528 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 121