HTC Desire 610 Charging Port Replacement

Step 1 Black Plastic Circuit Cover




• Using a plastic opening tool, take off the back cover of the phone.
Step 2

• Remove the four black 4mm torx screws using the Torx T5 bit.
Step 3
• Remove the four silver 5mm torx head screws using the Torx T5 screwdriver.
Step 4
• Remove the two 2.5mm phillips head screws using the Phillips 000 screwdriver.
Step 5
• Remove the black plastic circuit cover using a plastic opening tool.
Step 6 Charging Port
• Remove the 4mm black Torx screw using a Torx T5 screwdriver.
Step 7
• Using a pair of tweezers, disconnect the antenna wire.
Step 8
• Peel back the gray adhesive strip using the precision tweezers.
Step 9
• Pull up on the white strip so it sits 90 degrees using a pair of precision tweezers.
Step 10
• Pry up the circuit board and pull it out using a pair of precision tweezers.
Step 11
• Remove the loud speaker using a pair of precision tweezers.
• The loud speaker is attached with adhesive and may require more force than expected to remove.
• The prongs on the speaker should be sticking up towards the top of the phone when you put the speaker on the new circuit board.

Author

with 5 other contributors

Kaycee Hammond

Member since: 02/11/17

273 Reputation

2 Guides authored

Badges: 6

• 
• 
• 

+3 more badges

Team

IUPUI, Team S1-G1, Wilson Spring 2017 Member of IUPUI, Team S1-G1, Wilson Spring 2017

IUPUI-WILSON-S17S1G1

4 Members

6 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview