Introduction

This guide will outline the battery replacement process

To begin the disassembly of the device, place it on a flat surface with the screen facing down.
  • To begin the disassembly of the device, place it on a flat surface with the screen facing down.

Add Comment

Remove the four screws found on the back cover of the device.
  • Remove the four screws found on the back cover of the device.

Add Comment

Remove SD card on top of device by pushing and then releasing.
  • Remove SD card on top of device by pushing and then releasing.

Add Comment

Deck the Halls
With tools and Fix Kits
Carefully remove the back cover using the spudger against the grooves along the sides of the iPAQ.
  • Carefully remove the back cover using the spudger against the grooves along the sides of the iPAQ.

Add Comment

Using the plastic opening tool, carefully detach the yellow ribbon from the connector pins to separate the device into two halves.
  • Using the plastic opening tool, carefully detach the yellow ribbon from the connector pins to separate the device into two halves.

Add Comment

Using a heating pad or blow dryer, heat the back of cover until warm.
  • Using a heating pad or blow dryer, heat the back of cover until warm.

  • The glue holding in battery should now be loosened.

  • Use plastic opening tool to remove battery from the back cover.

Add Comment

Once the old battery is removed, scrape off the old adhesive from the device backing with the prying tool.
  • Once the old battery is removed, scrape off the old adhesive from the device backing with the prying tool.

  • To attach the new battery, apply an adhesive to each corner of the backing where the battery sits and place the device into the backing.

  • Allow the adhesive to set for half an hour

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 23

All Time: 340