1. Unplug the device from any energy sources.
    • Unplug the device from any energy sources.

    • Lift the top cover of the scanner.

    • Use a plastic opening tool to remove the plastic frame surrounding the glass.

    Add Comment

  2. Carefully pull the frame away from the glass.
    • Carefully pull the frame away from the glass.

    • If it doesn't remove easily, use the iFixit Opening Tool again to pry stuck sections.

    Add Comment

    • Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.

    Add Comment

    • Put your finger behind the panel with the power button.

    • Then, pull the piece outwards.

    Add Comment

    • Unscrew the screw inside the power button panel space.

      • Then, unscrew the screw that is across the printer slider.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Pull the white circuit board outwards which is located under the small screen.

    • Unplug the small ribbon cable from the circuit board.

    • Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Add Comment

    • Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Add Comment

    • Pull the memory card reader's circuit board out.

    • Detach the white wiring connector from the back of the circuit board.

    • You may need to use a finger nail or a plastic opening tool to detach the white wiring connector from the circuit board.

    Add Comment

    • Put your finger behind the small screen.

    • Then, pull it up.

    • Do not hesitate to use force to remove the TouchSmart panel.

    • Disconnect the ribbon cable from the small screen.

    Add Comment

    • Pull the printer hood upward.

    Add Comment

    • With the top half of the printer separated, lift the upper section with the scanner glass away from the lower section of the printer.

    Add Comment

    • With the glass facing upwards, remove the screw holding the glass in place.

    Add Comment

    • Lift the glass up and away from the printer.

    • Handle glass with care.

    • Replace the broken glass piece with the replacement glass

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

garrett hall

Member since: 09/26/2012

49 Reputation

2 Guides authored

Team

Cal Poly, Team 2-11, Propen Fall 2012 Member of Cal Poly, Team 2-11, Propen Fall 2012

CPSU-PROPEN-F12S2G11

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 2,471