Introduction

The scanner is found underneath the scanner glass. If this piece stops moving, you will not be able to scan anything. It may need to be cleaned or replaced at this point.

Open the top of the printer. The printer should appear as shown.
  • Open the top of the printer. The printer should appear as shown.

Add Comment

Use the blue plastic opening tool to pry the trim pieces all the way around the printer. Loosen the pieces around the edges before pulling to remove from the printer.
  • Use the blue plastic opening tool to pry the trim pieces all the way around the printer.

  • Loosen the pieces around the edges before pulling to remove from the printer.

  • Pull the (4) trim pieces off and set them aside.

Add Comment

Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels. The side trim pieces need to be removed before the front trim pieces.
  • Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels.

  • The side trim pieces need to be removed before the front trim pieces.

Add Comment

Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.
  • Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.

Add Comment

The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.
  • The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.

  • Keeping the scanner flap upright, slide it toward the unattached clip in order to dislodge the second clip.

  • Both clips will come unattached and you can set the scanner flap aside.

Add Comment

Lift the scanner glass piece from the printer and set it aside.
  • Lift the scanner glass piece from the printer and set it aside.

Add Comment

Gently pick up the scanner piece as shown to see the bottom side and wiring. Gently pick up the scanner piece as shown to see the bottom side and wiring.
  • Gently pick up the scanner piece as shown to see the bottom side and wiring.

Add Comment

Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece. Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece.
  • Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Charles

Member since: 10/23/2014

242 Reputation

2 Guides authored

Team

Michigan Tech, Team 1-2, Lauer Fall 2014 Member of Michigan Tech, Team 1-2, Lauer Fall 2014

MTU-LAUER-F14S1G2

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 7

Past 30 Days: 13

All Time: 396