HP Photosmart D110a Power Button Replacement

Step 1 Power Button

• Open the printer's mouth by pulling the two mouth pieces down.
• Lift the flap covering the scanner. When you are finished, the printer should appear as shown.
Step 2

• Remove the flap for the scanner by pulling lightly on the clip that attaches it to the printer.
• The clip may be damaged by applying too much force.
Step 3
• Remove the three screws from the top of the printer using a T9 screwdriver as shown.
• The screws are located in the far-left, far-right, and near-right corners of the printer, with respect to the front view.
Step 4
• Reach into the mouth of the printer and press the clip behind the power button to release the power button face.
Step 5
• A picture of the removed power button is provided to show the location of the clip that needs to be pressed.
• After pressing the clip, pull out the face of the power button by sliding it from the right to the left side.
Step 6
• The power button face has a plastic holder that attaches the power button and the wireless button to the face plate using two slots.
• Loosen the plastic holder by pulling the slots on the face plate away from the plastic holder.
• Remove the plastic holder from the face plate after the slots are loosened.
Step 7
• The plastic holder secures the power button by two slots.
• Using a spudger, push the holders inward to detach the button from the plastic holder.

Author

with 12 other contributors

Tim Wise

Member since: 04/01/11

173 Reputation

7 Guides authored

Badges: 9

• 
• 
• 

+6 more badges

Team

Cal Poly, Team 10-38, Forte Spring 2011 Member of Cal Poly, Team 10-38, Forte Spring 2011

CPSU-FORTE-S11S10G38

5 Members

10 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview