Introduction

Replace the wireless card in your HP Pavilion dv6000.

Image 1/1: Remove the two screws securing the RAM shield to the lower case.
  • Lay the laptop on a flat surface, battery side up.

  • Remove the two screws securing the RAM shield to the lower case.

  • The screws will remain captive within the shield.

  • Lift and remove the RAM shield up from the lower case.

Add Comment

Image 1/2: Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate. Image 2/2: Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.
  • Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.

  • Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.

Add Comment

Image 1/1: Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.
  • Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.

  • Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.

  • Grasp the wireless card and pull it straight out of its socket on the motherboard.

Add Comment

Image 1/1:
  • Wireless card remains.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Ben Hirsch

Member since: 10/05/2010

3,370 Reputation

10 Guides authored

Team

Cal Poly, Team 21-33, Regan Fall 2010 Member of Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 16

Past 30 Days: 90

All Time: 23,950