Introduction

Using a spudger and a 00 Phillips head screwdriver, this guide will show how to remove a web camera from an HP Omni 10 tablet in roughly 2 to 4 minutes.

Parts

No parts required.

Image 1/1: The cover is securely fastened to the device and may be difficult to remove.
  • Remove the back cover from the tablet.

  • The cover is securely fastened to the device and may be difficult to remove.

Add Comment

Image 1/1: Lift the small tab on the security strips up and peel them across the battery. They will be attached via adhesive.
  • Push the black plastic security flaps into an upward position.

  • Lift the small tab on the security strips up and peel them across the battery. They will be attached via adhesive.

  • Lift the tab on the strip up and pull it across the battery.

  • The orange strip does not fully detach from the tablet like the other three. It will only detach from one side.

Add Comment

Image 1/1:
  • Unscrew the ten 3.3 mm screws securing the battery using a 00 Phillip's head screwdriver.

Add Comment

Image 1/2: Pull the wire circuit out and down. Image 2/2: Pull the wire circuit out and down.
  • Unhook the cord from the edge of the battery.

  • Pull the wire circuit out and down.

Add Comment

Image 1/2: Image 2/2:
  • Lift the battery up by its edges and remove it carefully. There will be adhesive holding the battery down.

Add Comment

Image 1/1:
  • Unscrew the two 3.3 mm screws using a 00 Phillip's head screwdriver.

Add Comment

Image 1/1:
  • Lift and remove micro card reader board.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alex Miller

Member since: 10/11/2016

201 Reputation

5 Guides authored

Team

USF Tampa, Team 1-1, Leahy Fall 2016 Member of USF Tampa, Team 1-1, Leahy Fall 2016

USFT-LEAHY-F16S1G1

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 7

All Time: 63