Parts

No parts required.

Flip the device over so that the bottom side is facing up and use the Phillips #1 Screw Driver to remove the four 4mm screws on the cover panel. Lift the panel to remove it from the device.
  • Flip the device over so that the bottom side is facing up and use the Phillips #1 Screw Driver to remove the four 4mm screws on the cover panel.

  • Lift the panel to remove it from the device.

Add Comment

Remove the RAM by placing your thumbs on the silver tabs on each side of the RAM stick and pulling the tabs away from the RAM stick. The RAM stick should "flip" up when it is released from its holders. Pull the RAM stick toward you to remove it.
  • Remove the RAM by placing your thumbs on the silver tabs on each side of the RAM stick and pulling the tabs away from the RAM stick.

    • The RAM stick should "flip" up when it is released from its holders.

  • Pull the RAM stick toward you to remove it.

  • Repeat the above step to remove the second RAM stick

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Marshall Reid

Member since: 04/14/2014

473 Reputation

3 Guides authored

Team

Cal Poly, Team 12-38, Maness Spring 2014 Member of Cal Poly, Team 12-38, Maness Spring 2014

CPSU-MANESS-S14S12G38

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 5

All Time: 330