Skip to main content

HP Envy 15-u001dx Disassembly

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

What you need

  1. HP Envy 15-u001dx Disassembly, HP Envy 15-u001dx Disassembly: step 1, image 1 of 1
    • Remove the two no-slip covers on the rear, bottom side using spudger shown in top center of picture.

    • The two in the front do not have to be removed as there are no screws underneath them.

  2. HP Envy 15-u001dx Disassembly: step 2, image 1 of 1
    • Remove the two cover tabs towards center of the bottom as there are screws underneath them.

  3. HP Envy 15-u001dx Disassembly: step 3, image 1 of 1
    • Remove all fourteen 4.5 mm screws from the bottom using a Phillips #0 screwdriver. Each location is marked by a red circle in the picture.

  4. HP Envy 15-u001dx Disassembly: step 4, image 1 of 1
    • Separate the top cover by using a spudger to go around the sides freeing the inside latches.

    • Once the bottom is free, carefully open to the inside as there are two ribbons that connect your keyboard and touch pad to the top cover.

  5. HP Envy 15-u001dx Disassembly: step 5, image 1 of 2 HP Envy 15-u001dx Disassembly: step 5, image 2 of 2
    • Use the spudger to detach the two ribbons from their connectors.

    • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Dakota Presley

Member since: 10/05/16

885 Reputation

6 Guides authored

Team

USF Tampa, Team 9-4, Lacy Fall 2016 Member of USF Tampa, Team 9-4, Lacy Fall 2016

USFT-LACY-F16S9G4

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 35