Introduction

This guide will aid you in the replacement of your HP 7 1800 speaker. It requires beginning soldering skills.

Image 1/2: Slide the Spudger along the edge popping the tabs out along the way. Image 2/2: Be careful not to break the tabs.
  • Carefully insert a Spudger into one of the corners of the tablet.

  • Slide the Spudger along the edge popping the tabs out along the way.

  • Be careful not to break the tabs.

Add Comment

Image 1/3: Gently pull the cable connection from the motherboard using tweezers. Image 2/3: Gently pull the cable connection from the motherboard using tweezers. Image 3/3: Gently pull the cable connection from the motherboard using tweezers.
  • Slide the Spudger under the battery to lift it off the adhesive.

  • Gently pull the cable connection from the motherboard using tweezers.

Add Comment

Image 1/1:
  • Desolder the two leads of the speaker wire that are connected to the motherboard.

Add Comment

Image 1/1: The speaker is held onto the metal plate with light adhesive. It will require a little force to peel off.
  • Using tweezers, gently pull the speaker off of the metal plate.

  • The speaker is held onto the metal plate with light adhesive. It will require a little force to peel off.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Todd Dobrozdravic

Member since: 01/21/2015

675 Reputation

5 Guides authored

Team

USF Tampa, Team 4-1, Brown Winter 2015 Member of USF Tampa, Team 4-1, Brown Winter 2015

USFT-BROWN-W15S4G1

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 100