HP 15-dy2702dx Lower Case Replacement

Introduction

This guide explains how to replace the bottom panel of the HP 15-dy2072dx in case of warping, cracks, and any general wear and tear.

The bottom panel is responsible for covering most internal parts such as the battery, hard drive, memory, and the motherboard. The panel has the device information printed onto it such as the model number.

The panel usually comes equipped with two strips of rubber to allow for the laptop to rest on a hard surface. This is not always the case with secondhand panels.

What you need

Step 1 Lower Case

HP 15-dy2702dx Lower Case Replacement, Lower Case: step 1, image 1 of 1

Remove both of the rubber strips to uncover the hidden screws.
You can use a prying tool to help lift an end.

Edit

Step 2

Unscrew all 8 Phillips #0 screws on the bottom panel:
Two M2.5x6
Six M2x6

Edit

Step 3

Flip the laptop over and open the lid.
Separate the bottom panel from the main body by using the iFixit opening tool.
Ensure that the bottom panel is completely separated along the edges.

Edit

Step 4

If you can lift the laptop like shown in the first picture, the bottom panel is nearly separated.
Close the laptop to allow the back edges to fully separate

Edit