Introduction

This guide entails removing screws and hinge covers to remove the back panel.

Slide the two battery lock latches on the back of the device to the “unlock” position.
  • Slide the two battery lock latches on the back of the device to the “unlock” position.

Add Comment

Lift the battery upward to remove it from the device.
  • Lift the battery upward to remove it from the device.

Add Comment

  • Using the PH1 phillips-head screwdriver, remove all the 5/16 in. screws from the back of the device.

  • There should be 10 in total, be sure to keep them together!

Add Comment

  • Locate the optical disc drive and remove it from the device by sliding it straight of the device.

Add Comment

  • Covering the hinges of the device are rubber bumpers secured to the device using adhesive. Remove them carefully.

  • Place the adhesive side up as you will need to place them back after your replacement is complete.

Add Comment

  • In the same spot you’ve just removed the bumpers from, you will find two 5/16 in. screws. Using the same Phillips-head screwdriver used in step 2, remove the screws

  • Be sure to keep the screws together!

Add Comment

  • Carefully remove the back panel from the device.

  • If you are unable to do this with your hands, you can use a thin prying tool of your choice to make it easier!

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 7

Past 30 Days: 30

All Time: 454