Introduction

Sometimes a devices battery has been recharged too many times. This recharging causes the battery to diminish over time and hold less of a charge. The purpose of this guide is to demonstrate how to replace a bad or warn battery on the HMDX Jam Plus.

  1. Flip the device over so the bottom is facing up.
    • Flip the device over so the bottom is facing up.

    • Use the large plastic opening tool to gently pry the rubber base from the device.

    • Slowly move the plastic opening tool around the edge of the rubber base to separate it from the plastic.

  2. Use a Phillips #1 screwdriver to remove the four black 9mm screws from the device.
    • Use a Phillips #1 screwdriver to remove the four black 9mm screws from the device.

    • Gently separate the base from the rest of the device to reveal the battery and the main board.

    • Carefully use the plastic opening tool to remove the glue around the battery and speaker connectors.

    • Pull gently on the connectors to separate each one from the main board.

    • The battery is connected to board in the red socket and the speaker is connected in the white socket.

    • Batteries can be very dangerous if punctured. Use extra caution when using tools around the battery.

    • Use the plastic opening tool to gently pry the battery free from the rest of the device.

    • Use new adhesive to secure battery back to the rest of the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Maxwell Erickson

Member since: 10/22/2015

506 Reputation

4 Guides authored

Team

Montana Tech, Team 10-3, Shirk Fall 2015 Member of Montana Tech, Team 10-3, Shirk Fall 2015

MTUM-SHIRK-F15S10G3

4 Members

4 Guides authored

2 Comments

Where may battery be purchased?

Thanks,

zappenfusen

warnsdorff - Reply

Where can a battery be purchased?

robertwacker - Reply

View Statistics:

Past 24 Hours: 1

Past 7 Days: 17

Past 30 Days: 89

All Time: 2,838