Insert the plastic opening tool between the digitizer and the case.
  • Insert the plastic opening tool between the digitizer and the case.

  • Place the spudger in the gap created by the plastic opening tool to assist in separation.

Add Comment

Slide the spudger along the perimeter of the device to fully separate the two pieces. Slide the spudger along the perimeter of the device to fully separate the two pieces.
  • Slide the spudger along the perimeter of the device to fully separate the two pieces.

Add Comment

Peel off the tape that is attaching the wifi antenna to the case. Peel off the tape that is attaching the wifi antenna to the case.
  • Peel off the tape that is attaching the wifi antenna to the case.

Add Comment

Using the soldering iron, heat up the solder that is attaching the antenna to the motheboard.
  • Using the soldering iron, heat up the solder that is attaching the antenna to the motheboard.

  • The heat from the soldering iron may cause personal injury or damage the internal components of the tablet.

Add Comment

Suck up the leftover solder using the desoldering pump.
  • Suck up the leftover solder using the desoldering pump.

  • Remove the wifi antenna from the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan Gornati

Member since: 01/22/2015

401 Reputation

4 Guides authored

Team

USF Tampa, Team 7-6, Remmell Winter 2015 Member of USF Tampa, Team 7-6, Remmell Winter 2015

USFT-REMMELL-W15S7G6

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 70