Parts

No parts required.

Image 1/1: Place the spudger in the gap created by the plastic opening tool to assist in separation.
  • Insert the plastic opening tool between the digitizer and the case.

  • Place the spudger in the gap created by the plastic opening tool to assist in separation.

Add Comment

Image 1/2: Image 2/2:
  • Slide the spudger along the perimeter of the device to fully separate the two pieces.

Add Comment

Image 1/2: Image 2/2:
  • Use your fingers to pop the screen out from the digitizer.

Add Comment

Image 1/2: Image 2/2:
  • Use the tip of the spudger to release the latches on the motherboard.

Add Comment

Image 1/1:
  • Remove the cable from the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Spencer Pheasant

Member since: 01/20/2015

301 Reputation

3 Guides authored

Team

USF Tampa, Team 7-6, Remmell Winter 2015 Member of USF Tampa, Team 7-6, Remmell Winter 2015

USFT-REMMELL-W15S7G6

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 79