Introduction

This guide describes the necessary steps to remove the back panel of the device. This is a prerequisite for accessing all of the internal components of the device.

Parts

No parts required.

Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.
  • Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.

  • Flip your device over so the bottom panel is facing up.

Add Comment

Peel off the black rubber strips from top and bottom of the back panel.
  • Peel off the black rubber strips from top and bottom of the back panel.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove the fifteen 3 mm Phillips #00 screws from the back panel. Remove the fifteen 3 mm Phillips #00 screws from the back panel.
  • Remove the fifteen 3 mm Phillips #00 screws from the back panel.

Add Comment

Carefully lift the back panel off of the device.
  • Carefully lift the back panel off of the device.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Garrett Monteiro

Member since: 04/26/2017

101 Reputation

1 Guide authored

Team

Cal Poly, Team S22-G6, Livingston Spring 2017 Member of Cal Poly, Team S22-G6, Livingston Spring 2017

CPSU-LIVINGSTON-S17S22G6

4 Members

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 8

Past 30 Days: 47

All Time: 142