Tools

No tools required.

Power off your GoPro before beginning disassembly.
  • Power off your GoPro before beginning disassembly.

  • Unclip the black latch to the camera case and open the case.

Gently pry the back open by inserting a metal spudger between the case and back panel.
  • Gently pry the back open by inserting a metal spudger between the case and back panel.

Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.
  • Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.
  • Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.

Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.
  • Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.

    • Make sure to keep track of these screws as they are very small.

Carefully remove the motherboard and white plastic piece from the case.
  • Carefully remove the motherboard and white plastic piece from the case.

Remove the larger ribbon cable from the daughter board by lifting the black latch and pulling the ribbon cable gently from the socket. Disconnect the smaller ribbon cable leading from the white plastic piece by simply pulling it from the socket.
  • Remove the larger ribbon cable from the daughter board by lifting the black latch and pulling the ribbon cable gently from the socket.

  • Disconnect the smaller ribbon cable leading from the white plastic piece by simply pulling it from the socket.

Remove the two screws located on each side of the board with a Phillips screwdriver.
  • Remove the two screws located on each side of the board with a Phillips screwdriver.

    • The screws go through an L metal bracket that will come off with the screws.

Separate the daughter board from the white plastic piece.
  • Separate the daughter board from the white plastic piece.

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

River Drake

Member since: 04/02/2015

899 Reputation

10 Guides authored

Team

Cal Poly, Team 12-2, Lancaster Spring 2015 Member of Cal Poly, Team 12-2, Lancaster Spring 2015

CPSU-LANCASTER-S15S12G2

4 Members

12 Guides authored

Wo kann ich ein daughterboard kaufen habt ihr da was für mich?

Lukas Blohm - Reply

bravo! è scritto molto bene ed è stato utile. ma dove trovo il ricambio? non ci riesco!!!

michele - Reply

Add Comment

View Statistics:

Past 24 Hours: 5

Past 7 Days: 23

Past 30 Days: 63

All Time: 2,435