Fix Your Stuff Community Store

Free Shipping on Domestic Orders $75+

Ghost Longboard Wheel Replacement

Introduction

Use this guide to replace the damaged, warped, or dented wheels on your Ghost Longboard. This guide requires minimal skill and no prior experience. It is especially useful if your board is not as fast as it used to be, it has become more difficult to turn, or it does not coast for as long as you would like it to. the ghost longboard wheels are easy to replace.

What you need

  1. Ghost Longboard Wheel Replacement, Wheel: step 1, image 1 of 1

    • Using a 15 mm socket wrench, unscrew the axle nut.

    Edit
    Ask FixBot

    Add Comment

  2. Ghost Longboard Wheel Replacement: step 2, image 1 of 1

    • Using your fingers, remove the axle nut from the axle.

    Edit
    Ask FixBot

    Add Comment

  3. Ghost Longboard Wheel Replacement: step 3, image 1 of 1

    • Remove the washer from the axle.

    Edit
    Ask FixBot

    Add Comment

  4. Ghost Longboard Wheel Replacement: step 4, image 1 of 1

    • Remove the wheel from the axle.

    Edit
    Ask FixBot

    Add Comment

  6. Ghost Longboard Wheel Replacement: step 5, image 1 of 1

    • Remove the second washer from the axle.

    Edit
    Ask FixBot

    Add Comment

  7. Ghost Longboard Wheel Replacement: step 6, image 1 of 1

    • Slide a new washer onto the axle.

    Edit
    Ask FixBot

    Add Comment

  8. Ghost Longboard Wheel Replacement: step 7, image 1 of 2 Ghost Longboard Wheel Replacement: step 7, image 2 of 2

    • Place the new wheel on the axle.

    • Be sure to position the flat side of the wheel so it is facing inward.

    Edit
    Ask FixBot

    Add Comment

  9. Ghost Longboard Wheel Replacement: step 8, image 1 of 1

    • Place a second washer on the axle exterior to the wheel.

    Edit
    Ask FixBot

    Add Comment

  10. Ghost Longboard Wheel Replacement: step 9, image 1 of 1

    • Place an axle nut on the axle.

    Edit
    Ask FixBot

    Add Comment

  11. Ghost Longboard Wheel Replacement: step 10, image 1 of 1

    • Using a 15 mm socket wrench, tighten the axle nut.

    • Be sure to tighten the axle nut enough to prevent the wheel from wobbling, but not so tight as to prohibit the wheel from spinning freely.

    Edit
    Ask FixBot

    Add Comment

Conclusion

Repeat these steps on the three remaining wheels.

Cancel: I did not complete this guide.

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 4

Past 30 Days: 39

All Time: 627