Fix Your Stuff Community Store

General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement

Introduction

Use this guide to replace the reverse switch on a General Pipe Cleaners Drain Cleaner EJB 2014.

What you need

  1. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement, Reverse Switch: step 1, image 1 of 1

    • Before you begin, make sure the drain cleaner is disconnected from power.

    • Use a Phillips #2 driver to remove the two screws securing the control box cover.

    Edit

  2. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 2, image 1 of 1

    • Remove the control box cover.

    Edit

  3. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 3, image 1 of 1

    • Use a 9/16 inch deep socket and ratchet to remove the nut securing the reverse switch.

    Edit

  5. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 4, image 1 of 2 General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 4, image 2 of 2

    • Remove the reverse switch guard.

    Edit

  6. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 5, image 1 of 2 General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 5, image 2 of 2

    • Squeeze the tabs on either side of the reverse switch connector.

    • Pull the two halves of the connector apart to disconnect it.

    • Take note of where everything is connected in the control box before disconnecting anything else.

    Edit

  7. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 6, image 1 of 2 General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 6, image 2 of 2

    • Pull the white cable straight off of its spade connector on the power switch diaphragm.

    Edit

  8. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 7, image 1 of 2 General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 7, image 2 of 2

    • Pull the black cable straight off of its spade connector on the power switch diaphragm.

    Edit

  9. General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 8, image 1 of 3 General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 8, image 2 of 3 General Pipe Cleaners Drain Cleaner EJB 2014 Reverse Switch Replacement: step 8, image 3 of 3

    • Slide the switch assembly down out of its hole in the control box and pull it out of the control box.

    • Be careful not to snag the switch on any cables during removal.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Author

Adam O'Camb

Member since: 04/11/15

197,111 Reputation

416 Guides authored

Badges: 39

+36 more badges

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 18

All Time: 983