Introduction

Before disassembling anything be sure that the device is powered off. This installation is much easier for those familiar with the use of soldering irons. Those who have never used one before should look at this guide.

Image 1/2: Pry the outer frame off the perimeter of the rear panel assembly. Image 2/2: The cover will easily pop off.
  • Wedge a plastic opening tool in between the outer frame and the rear panel assembly.

  • Pry the outer frame off the perimeter of the rear panel assembly.

  • The cover will easily pop off.

Add Comment

Image 1/2: Carefully lift, but do not completely separate, the front case assembly from the rear case assembly. Image 2/2: Be extremely cautious when separating both halves, as the rear case assembly is still attached to the front case assembly via a few connectors.
  • Remove the four #00 Phillips screws securing the front case assembly to the rear case assembly.

  • Carefully lift, but do not completely separate, the front case assembly from the rear case assembly.

  • Be extremely cautious when separating both halves, as the rear case assembly is still attached to the front case assembly via a few connectors.

Add Comment

Image 1/1: The second connector can remain attached to the motherboard, but be careful not to break the connector while handling both halves of the device.
  • Gently pull the battery cable connector from its socket on the motherboard.

  • The second connector can remain attached to the motherboard, but be careful not to break the connector while handling both halves of the device.

Add Comment

Image 1/1: Remove the two #00 Phillips screws securing the battery to the rear case assembly.
  • Do not disconnect the black wire. Doing so may cause severe damage to your device.

  • Remove the two #00 Phillips screws securing the battery to the rear case assembly.

Add Comment

Image 1/2: Cautiously grasp the battery and lift it out of the device. Image 2/2: Cautiously grasp the battery and lift it out of the device.
  • Use a plastic opening tool to peel back the battery bracket.

  • Cautiously grasp the battery and lift it out of the device.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Arturo Barajas

Member since: 01/18/2012

11 Reputation

3 Guides authored

Team

Cal Poly, Team 11-19, Maness Winter 2012 Member of Cal Poly, Team 11-19, Maness Winter 2012

CPSU-MANESS-W12S11G19

4 Members

4 Guides authored

One Comment

Where can I purchase a new Garmin StreetPilot c320 Battery Replacement battery?

john Lyons

11 Cavanaugh Cres

Terrace Bay Ontario

P0T2W0 Canada

John Lyons - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 2,179