Introduction

If your power button is defective, replace the old one with the new power button.

Image 1/1:
  • Remove the barcode sticker at the bottom of the device.

Add Comment

Image 1/1:
  • Remove two 8.4 mm T5 screws from the bottom of the device.

Add Comment

Image 1/2: Open the device carefully, making sure not to damage the gold ribbon cable that connects the screen to the motherboard. Image 2/2: Open the device carefully, making sure not to damage the gold ribbon cable that connects the screen to the motherboard.
  • Using a plastic opening tool, carefully pry open the device.

  • Open the device carefully, making sure not to damage the gold ribbon cable that connects the screen to the motherboard.

turn the unit around

Andrew Hayden - Reply

Since there is no replacement speaker whats the point of this process?

greg - Reply

Very detailed set of instructions! Does anyone known the thread size of the screws in step 2? 8.4 mm T5 screws: is the length of the screw (8.4 mm) ,and the head specification (T5- size of screw driver). I need the actual thread specification. I lost one of the screws and the other one 's head is stripped. I need to replace both screws.

Harold Schultz - Reply

Image 1/2: Image 2/2:
  • Remove the power button.

Where can I buy the button

milosvalek - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

Timothy

Member since: 01/26/2012

35 Reputation

3 Guides authored

Team

Cal Poly, Team 9-3, Regan Winter 2012 Member of Cal Poly, Team 9-3, Regan Winter 2012

CPSU-REGAN-W12S9G3

5 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 35

All Time: 8,841