Replacing Garmin Nuvi 200 Display

Step 1 Rear Casing



• Peel off the sticker from the bottom of the device to reveal two screws.
Step 2

• Remove two T5 Torx screws.
Step 3
• Insert a plastic opening tool in the gap between the front and rear casing.
• Carefully work the tool around the gap, separating the two halves of the case.
• Keep the power switch in place while removing the rear case.
Step 4 Display
• Apply pressure to the tabs holding the screen in place with the plastic opening tool
Step 5
• Apply pressure to the same tabs again to remove the front of the screen.
Step 6
• Peel away the material holding the ribbon cable in place.
• Peeling the sticker halfway will allow you to access the ribbon cable. Removing it fully will allow you to detach the upper case from the lower case.
Step 7
• Disconnect the ribbon cable from the logic board.
• Make sure to disconnect the cable from both ports.
Step 8
• The display consists of two screens which are held together by the ribbon.

Author

with 6 other contributors

Nick

Member since: 04/11/10

7 Reputation

1 Guide authored

Badges: 8

• 
• 
• 

+5 more badges

Team

Cal Poly, Team 25-90, Amido Spring 2010 Member of Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 Members

9 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview