Introduction

Be very careful when handling connector wires, as they are incredibly easily broken. This guide is unique only in removing the circuit board from the screen.

What you need

Step 1 Back Cover

Garmin Approach S2 Motherboard Replacement, Back Cover: step 1, image 1 of 2

Garmin Approach S2 Motherboard Replacement, Back Cover: step 1, image 2 of 2

Remove the six T5 Torx 6.32mm screws securing the back cover to the watch.

Edit

Step 2

Remove the back cover carefully.
Even after the screws have been removed, the back cover can still be quite difficult to take off. Moderate to extensive prying may be required. Be gentle, but firm.

Edit

Step 3 Water Proof Gasket

Garmin Approach S2 Motherboard Replacement, Water Proof Gasket: step 3, image 1 of 1

Remove the orange gasket.

Edit

Step 4 Screen

Garmin Approach S2 Motherboard Replacement, Screen: step 4, image 1 of 1

Remove the screen and motherboard assembly from the case.

Edit

Step 5

Use a metal spudger to remove the golden retaining clip from the screen. There will be some adhesive to break.

Edit

Step 6

Remove the screen from the golden metal clip.

Edit

Step 7

Unhinge the black retaining hinge by prying it open with the metal spudger; Your fingernails will work as well.

Edit

Step 8

Remove the connector from the motherboard by pulling it free at the base.
Make sure to pull from the base of the connector wire, as it is very easy to rip the wire from the screen.

Edit