Game Boy Micro Battery Cover Replacement

Student-Created Guide

Student-Created Guide

An awesome student from our education program made this guide. It is not managed by iFixit staff.

Step Trimmer

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

  • Author: Jack
  • Time required: 10 minutes
  • Difficulty: Very easy

Use this guide to remove the battery cover and battery from the Game Boy.

Edit Step 1 Battery Cover  ¶ 

Image #1

Edit Step 1 Battery Cover  ¶ 

  • Remove the Phillips #00 screw on the side of the Game Boy closest to the directional pad.

  • Once the screw has been loosened, lift the cover off the back of the device.

Edit Step 2  ¶ 

Image #1

Edit Step 2  ¶ 

  • Once the back cover is removed, you should see that the battery is connected to the device by two wires and a plastic connector.

  • Gently grab the wires.

Edit Step 3  ¶ 

Image #1

Edit Step 3  ¶ 

  • Carefully pull the wires until the connector comes out of the device.

  • Be careful! Don't pull too hard, or you may rip the wires out from the connector.

  • When putting the battery back into the device, make sure the connector is put in exactly the way it came out.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the Game Boy Micro device page.

Required Tools

Phillips #00 Screwdriver

$5.95 · 50+ In stock

Recommended Tools

54 Bit Driver Kit

$29.95 · 50+ In stock

Pro Magnetic Project Mat

$19.95 · 50+ In stock

Pro Tech Screwdriver Set

$59.95 · 50+ In stock

Anti-Static Project Tray

$4.95 · 50+ In stock

Popular Products

T6 Torx Screwdriver

$9.95 · 18 In stock

1.5" Thin Putty Knife

$6.95 · 50+ In stock

Small Suction Cup

$2.95 · 50+ In stock

Comments Comments are onturn off

No comments.

View Statistics:

Past 24 Hours: 0

Past 7 Days: 21

Past 30 Days: 84

All Time: 8,127