Introduction

Before attempting repairs, please take note of certain risks of receiving shock from the camera's flash capacitor. Also make sure to ground yourself before operating on the camera's motherboard or you might discharge static to crucial components.

Parts

No parts required.

Image 1/3: Image 2/3: Image 3/3:
  • First, push in the lens and remove the two AA batteries.

Add Comment

Image 1/2: Image 2/2:
  • Open the rear compartment and remove the film cartridge.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Remove screws from bottom of camera with a small #00 Phillips Screwdriver. Then remove screws around the camera. Additionally, there are two screws in the battery compartment which also need to be removed.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Once all screws are removed, gently pry open the front casing with your hands or plastic opening tools carefully. Do note that there will be a spring that attaches the front casing and the main circuit board, so refrain from allowing excess tension on the spring.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Locate the IR blaster, remove the connecting wire ribbon by prying the connector latch open on the motherboard, then sliding it out. Once the wire ribbon is disconnected, the IR blaster can be lifted away from the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Boyang Wu

Member since: 10/02/2012

604 Reputation

5 Guides authored

Team

USF Tampa, Team 4-1, Meier Fall 2015 Member of USF Tampa, Team 4-1, Meier Fall 2015

USFT-MEIER-F15S4G1

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 7

Past 7 Days: 32

Past 30 Days: 158

All Time: 2,055