Introduction

The shutter button allows for the taking of pictures. This guide will explain how to get to and remove the shutter button and components that are associated with it.

Remove the screws from the bottom of the camera using the tri-wing screwdriver.
  • Remove the screws from the bottom of the camera using the tri-wing screwdriver.

    • Three 5.4 mm tri-head screws.

Add Comment

Remove screws from charger side of camera using the Phillips 00 screwdriver.
  • Remove screws from charger side of camera using the Phillips 00 screwdriver.

    • Two 3.3 mm Phillips #00 screws.

Add Comment

Remove screws from wrist-strap side of camera using the Phillips 00 screwdriver.
  • Remove screws from wrist-strap side of camera using the Phillips 00 screwdriver.

    • Two 3.3 mm Phillips #00 screws.

Add Comment

Separate the front and back casing using the spudger. Gently pull apart the two casings. Pull the back casing away from the camera.
  • Separate the front and back casing using the spudger.

  • Gently pull apart the two casings.

  • Pull the back casing away from the camera.

Add Comment

Remove screws from the casing covering the LCD using the Phillips 00 screwdriver.
  • Remove screws from the casing covering the LCD using the Phillips 00 screwdriver.

    • Remove the fifteen 2.9 mm Phillips #00 screws.

Add Comment

Slide casing out using the spudger.
  • Slide casing out using the spudger.

Add Comment

Gently remove the LCD display data cable by gripping the end that is connected to the motherboard and pulling out. Gently remove the LCD display data cable by gripping the end that is connected to the motherboard and pulling out.
  • Gently remove the LCD display data cable by gripping the end that is connected to the motherboard and pulling out.

Add Comment

Pull on the shutter button display data cable on the end connected to the motherboard until it slides out. Pull on the shutter button display data cable on the end connected to the motherboard until it slides out.
  • Pull on the shutter button display data cable on the end connected to the motherboard until it slides out.

Add Comment

While slightly rotating the shutter button and data cable counter-clockwise, pull out until whole component comes out. When inserting the new shutter button and data cable component, be sure it is placed properly into the camera or it will not function correctly.
  • While slightly rotating the shutter button and data cable counter-clockwise, pull out until whole component comes out.

    • When inserting the new shutter button and data cable component, be sure it is placed properly into the camera or it will not function correctly.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Sarah Looper

Member since: 03/11/2013

71 Reputation

7 Guides authored

Team

Clemson, Team 13-4, Benson Spring 2013 Member of Clemson, Team 13-4, Benson Spring 2013

CLEM-BENSON-S13S13G4

2 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 737