Parts

No parts required.

  1. Flip device upside down and remove the 4 foam pads at each corner.
    • Flip device upside down and remove the 4 foam pads at each corner.

    Add Comment

    • Remove the 4 screws using a Philips Screwdriver.

    Add Comment

    • Gently lift the case off of the body and set down in a safe place.

    Add Comment

  2. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unscrew the 5 screws in the base circuit board.

    Add Comment

    • Use the tweezers to slightly lift the circuit board, allowing the cylindrical alarm piece to slide out.

    Add Comment

    • Check if the wires are secured.

    Add Comment

    • If they are not attached, you may re-solder it together. If they are attached, that means it is a faulty alarm and should replace it.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 623