Skip to main content

Introduction

If you determine that your vacuum is no longer picking up debris, this guide will help you to replace the washable filters to increase the suction.

  1. Press the grey dust cup release button and gently pull the dust cup towards you. Press the grey dust cup release button and gently pull the dust cup towards you.
    • Press the grey dust cup release button and gently pull the dust cup towards you.

  2. Lift the latch on the top of the dust cup cover to open. You can now see the foam filter inside the cyclone portion of the dust cup. Lift the latch on the top of the dust cup cover to open. You can now see the foam filter inside the cyclone portion of the dust cup.
    • Lift the latch on the top of the dust cup cover to open. You can now see the foam filter inside the cyclone portion of the dust cup.

  3. Remove the white filter by lifting the gray foam filter handle.
    • Remove the white filter by lifting the gray foam filter handle.

  4. Push the white mesh, segment below the filter handle downward so it pops out of the grey filter holder. This will remove the filter.
    • Push the white mesh, segment below the filter handle downward so it pops out of the grey filter holder. This will remove the filter.

  5. If filter is unable to be washed, place a new filter in gray holder.
    • If filter is unable to be washed, place a new filter in gray holder.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Celina Burchett

Member since: 10/13/2014

1,101 Reputation

8 Guides authored

Team

Clemson, Team 2-2, Benson Fall 2014 Member of Clemson, Team 2-2, Benson Fall 2014

CLEM-BENSON-F14S2G2

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 22

All Time: 3,560