Introduction
If your Ersa i-CON Display is broken, use this guide to get your soldering station working again with a new display.
Replacement displays are available from kurtz ersa under the part number 3EBLCD128X64 and Orient Display under the part number AMG12864PR-G-B12WTDW.
What you need
-
-
Tool used on this step:Spudger$3.99
-
Pull off the control knob using a nylon spudger.
Ask FixBot
-
-
Tool used on this step:iFixit Precision 4 mm Screwdriver Bit$2.99
-
Flip the station over and remove the four T20 screws.
-
Flip the station back onto its base and lift the top cover up and off the station.
-
-
-
-
Use pliers or a wrench to unscrew the four plastic nuts holding the display in place.
-
-
Tool used on this step:Spudger$3.99
-
Carefully flip the display upwards.
-
Loosen the display connector by pushing up the small brown bars on both sides of the connector with a spudger or similar tool.
-
Pull the ribbon cable from the connector.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
