remove the battery door using either your finger nail or a screwdriver.
  • remove the battery door using either your finger nail or a screwdriver.

Add Comment

Then remove the three screws on the back cover using a philips screwdriver #1.
  • Then remove the three screws on the back cover using a philips screwdriver #1.

Add Comment

  • Remove the black back cover with your hand and be careful not to cut the wires attached on the cover.

Add Comment

  • Using a screwdriver #1, remove the 2 small screws located at the top and bottom of the alarm switch.

Add Comment

  • Using soldering iron, detach wire end from the copper cylinder by plaint the end of the iron to the end of the wire. Now you can replace the alarm switch with a new one by attaching one end of the wires to the copper cylinder . Then install the switch screws using the screwdriver.

Add Comment

  • a photo of the steps we have been through in working on the clock and a photo of the tools we used and the clock parts during disassembly

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 362