Fix Your Stuff Community Store

Epson Powerlite 410W Motherboard Replacement

What you need

  1. Epson Powerlite 410W Motherboard Replacement, Top Cover: step 1, image 1 of 1

    • Press the power button located on top of the projector.

    • Remember to let the projector cool off completely after turning off the power before beginning the repair.

    Edit

  2. Epson Powerlite 410W Motherboard Replacement: step 2, image 1 of 1

    • Remove eight screws from the bottom of the device using a Phillips #00 screwdriver.

    Edit

  3. Epson Powerlite 410W Motherboard Replacement: step 3, image 1 of 3 Epson Powerlite 410W Motherboard Replacement: step 3, image 2 of 3 Epson Powerlite 410W Motherboard Replacement: step 3, image 3 of 3

    • Turn the projector so the power button is on top.

    • Gently pull up the cover until it pops off.

    • Do not pull too far; a ribbon cable still connects the top cover to the motherboard.

    • Disconnect the ribbon cable that attaches the cover to the motherboard.

    • Remove the cover and place to the side.

    Edit

  5. Epson Powerlite 410W Motherboard Replacement, Motherboard: step 4, image 1 of 2 Epson Powerlite 410W Motherboard Replacement, Motherboard: step 4, image 2 of 2

    • Remove the two screws holding down the motherboard using a Phillips #00 screwdriver.

    • Remove the four screws holding down the I/O board using a Phillips #00 screwdriver.

    Edit

  6. Epson Powerlite 410W Motherboard Replacement: step 5, image 1 of 1

    • Remove the seven cables that are running to the motherboard by pulling them out of their sockets.

    Edit

  7. Epson Powerlite 410W Motherboard Replacement: step 6, image 1 of 3 Epson Powerlite 410W Motherboard Replacement: step 6, image 2 of 3 Epson Powerlite 410W Motherboard Replacement: step 6, image 3 of 3
    Tool used on this step:
    Tweezers
    $4.99
    Buy

    • Using a plastic opening tool, gently pry up the black tabs holding in the ribbon cables on the motherboard.

    • Using tweezers, gently pull the ribbon cables out of the sockets.

    Edit

  8. Epson Powerlite 410W Motherboard Replacement: step 7, image 1 of 1

    • Gently pull the motherboard up and tilt it back, revealing the last cable attached to the motherboard. Disconnect this cable.

    • Remove the motherboard from the projector.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 81