Epson Powerlite 410W Air Filter Replacement

Introduction

The air filter is a key part of the Epson PowerLite 410W that keeps the intake air clean and free of particulates that may impede or damage the projector. When cleaning the air filter, make sure to not rip the mesh or get it wet as this can lead to damage to the projector.

If you wish to clean your air filter before replacing it with a new one due to a clogged vent, refer to the troubleshooting page as there are a few different ways to do this. To remove large debris, lightly tap both sides of the air filter. To clean smaller debris, take a brush and lightly brush the filter to remove any dust and debris; a vacuum can be effective at removing dust as well. A can of compressed air will also quickly remove dust, but make sure to hold the can upright.

Step 1 Air Filter

Epson Powerlite 410W Air Filter Replacement, Air Filter: step 1, image 1 of 3

Epson Powerlite 410W Air Filter Replacement, Air Filter: step 1, image 2 of 3

Epson Powerlite 410W Air Filter Replacement, Air Filter: step 1, image 3 of 3

When looking at the lens-side of the projector, the air filter will be a thin black line on the far right.
Gently pull the air filter perpendicular to the projector body.

Edit