Needs More Images
A few more images would make this guide's procedures crystal clear.
Community-Contributed Guide
An awesome member of our community made this guide. It was not created by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
-
-
-
Place the computer upside down on a clean, flat surface. Remove the bottom of the base assembly
-
Remove the bottom of the base assembly
-
-
-
Remove the four M3 x 3-mm screws (marked with an "H") that secure the hard drive
-
-
-
Remove the M3 x 3mm screw from the bezel and take the bezel off the hard drive.
-
-
-
-
Attach the bezel to the hard drive using the M3 x 3mm screw.
-
Slide the hard drive into the bay until it is fully seated
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.